View Single Post
Old 07-04-2008, 12:51 AM
Ardee Ardee is offline
Join Date: Jul 2008
Location: So. California
Posts: 2
Default Re: Sharpening the lindsay Point on a faceting machine

I am learning sharpening now, have to get through it to learn engraving....I am also trying to use my facet machine with a pin vise (though my pin vise is a little different than yours). And my pin vise with graver is not quite true so my cuts will be off a little but hoping it will work for now.
I am wondering if you would help me out by, sharing with me what your index gear numbers you used and what angle degrees you used verticly to achieve the correct facet angles ? I am also using a 96 index wheel and have currently gone so far as to tape over the original numbers of the index wheel and am placing my own .....does that make any sense ? It is hard to explain.

Reply With Quote