Thread: Help!!!
View Single Post
  #1  
Old 10-20-2019, 03:53 PM
MikeRoyse MikeRoyse is offline
Steel
 
Join Date: Oct 2018
Location: OHIO
Posts: 10
Default Help!!!

After many prac plates and classes I have decided to engrave the bolster of one of my Mtech knives and keep breaking the tool tip OR the tool just skates across the surface. I have a artisan handpiece set up and using a 105 deg tool. where to go from here. Im figurig the knife bolster is harder than the steel prac plates I have from Lindsey.

thanks in advance!
Reply With Quote