Re: NitroG20 AirGraver
Hi Dave, I already made it. It was no problem. I left it set up in the mill in case you had oversized 1/8" shanks. I measured some 1/8" square tools bits I had and found one at .126". So I opened the slot up to that size already. I'll call it good there and pull it out of the mill. I can install it in one of the sharpening fixtures and calibrate for you, so the square slot is lined up with the plastic templates and ship that way (you could return the one you have then), or should I just ship the collet and you can square it up yourself in the sharpening holder you have?
PS... I just read your post again. Okay, I'll install it in a second holder and ship that way.
|