[SEngraver]

Originally Posted by briar

Hi all,

I read somewhere that the grave needs an angle ground on the end of it before you can cut metal with it. I have no way of doing this. Any suggestions.

!

Hi Briar,
If you get a sharpening fixture with some different V angle or flat templates you can sharpen all sorts of gravers points ,the basic I can suggest are V96,V116 and a flat and knife combination templates to start with the diamond bench stone set,for grinding the points ;

http://www.airgraver.com/sharpening.htm

Also get some hss,M42,and some carbalt graver blanks to make these points from.When you make points from these blanks they will cut almost any metal.
Nice work there by the way, .
SE