View Single Post
  #14  
Old 03-26-2008, 04:02 AM
vilts's Avatar
vilts vilts is offline
Steel
 
Join Date: Apr 2007
Location: Estonia
Posts: 96
Send a message via Skype™ to vilts
Default Re: Engraving coining dies

This is very interesting. I'd like to give a go at making some coins or similar myself some time.

But when you use oil or water hardening steels and you heat treat them after engraving, then how do you clean it up afterwards? Both water and oil hardening creates very messy surface...
Reply With Quote